Plastic Injection Molding Process Setup Specialist

Job Description Job Description Can you take a mold from rack to repeatable production, fast?

Picture this: a new job hits the floor. You hang the tooling, square it up, and bring the press to life. First-off parts look close, and with a few adjustments-always by the book-you lock in a stable process. Hours later, a hiccup appears mid-run. You spot the root cause and correct it before output is impacted. That is your craft.

Role highlights

• Prepare presses by hanging and setting up tooling, then start production jobs to target cycle and quality.
• Adjust and troubleshoot during runs while following established work instructions.
• Handle mold tooling inventory control to ensure availability and traceability.
• Conduct press teardown and complete mold pulls per procedure.
• Support general shop upkeep: cleaning, organization, and basic maintenance.
• Enter downtime codes and tool setup information accurately in the ERP system.
• Continuously verify press health; report any issues to the supervisor promptly.

What it takes

• High school diploma, GED, or 12 years of formal education preferred (not required).
• Competence with basic mathematics.
• Ability to read, write, and communicate effectively in English; bilingual English/Spanish is a plus.
• Preferred: 5+ years of hands-on injection molding experience.
• Strong mechanical experience and a practical problem-solving mindset.
• Physical ability to lift 60+ pounds, climb stairs, and stand for up to 8 hours.
• Ability to operate a forklift.

Proficiency

• Injection molding experience.